Konica Minolta cm-5 Instruction Manual page 158

Initial Settings
* Initialization of the instrument will reset the settings to the initial values shown in the table below.
The sample data, target color data and the tolerances set for each target color are protected and not cleared by
the initialization.
* The zero calibration data will be reset to the factory-set data.
If you performed zero calibration due to a change in the measurement environment, you will need to perform
zero calibration again after the initialization.
* In certain cases, the instrument is initialized due to another cause other than the initialization operation (e.g.
when the built-in backup battery life expired). In this case, the sample data, target color data and tolerance
settings will also be reset to the initial status (no sample data, no target color data, default tolerance settings).
Zero Calibration/0% Calibration
White Calibration/100% Calibration
User Calibration
Measurement
condition
Measurement
option
Color condition
Calibration option
Graph
Output
Screen option
System
E156
Item
Measurement Type
Measurement Area
SCI/SCE
Auto Measurement
Manual Measurement
Shutter Open/Close
Color Space
Difference Formula Settings
Color Index
Observer
Illuminant 1
Illuminant 2
Auto White Calibration
Calibration Data
Custom Display
screen
Line item
Column item
Color Assessment
Spectral Spectral data display
graph
Selected wavelength
Serial printer Auto Print
Baud Rate
USB memory File Format
Wizard Screen
LCD Brightness
Display language
Date Format
Periodic Message
Initial setting
Completed (factory-set value)
Not performed
Not performed
Reflectance measurement (Ref)
ø30 mm
SCE
No. of measurements: 1
No. of measurements: 1
Close
L*a*b*
ΔE*ab
None
10°
D65
None
ON
White Calibration
ON
L*,a*,b*,C*,h
Sample data, target color, and
color difference measured with
illuminant 1
OFF
ON
450 nm, 550 nm , 650 nm
OFF
9600 bps
CSV1
ON
3 (Standard)
English
MM/DD/YYYY
ON