Connecting To An External Device; Connecting A Usb Memory - Konica Minolta cm-5 Instruction Manual

Connecting to an External Device

The instrument features two USB connection terminals, one for connecting a USB memory or a USB keyboard
and one for connecting a PC, and an RS-232C connector. USB memory can be used for saving data or various
conditions, and a USB keyboard can be used for text input when editing sample data names. Moreover, the
supplied USB cable (IF-A19) can be used to connect the instrument to a PC to transmit data.
• Only use the prescribed equipment and cables with the two types of USB cables and RS-232C connector.
Notes
• When the instrument is exposed to strong external static electricity or is affected by ambient interference during
communication with an external device, the communication may be interrupted. In this case, turn the power
OFF and then turn it ON again.

Connecting a USB Memory

You can save the conditions, sample data, and target color data stored in the memory of the instrument into a
USB memory as a file. You can load this condition file from the USB memory to the instrument and set the
conditions all at once.
• USB memory devices with no security features are supported.
Notes
• Make sure that the USB memory is oriented correctly and connected securely.
• To connect the USB memory, check the shape of the receptacle (connection terminal) and insert the connector
fully until it is secured.
The USB connection terminal of the instrument conforms to USB 1.1.
Memo
[Operating Procedure]
A USB memory can be connected or disconnected even while the instrument is turned ON.
1. Connect the USB memory to the USB connection terminal
(A type).
Fully insert the connector and ensure that it is connected
securely.
When the USB memory is properly connected,
memory connected) is displayed on the screen.
Disconnect any USB keyboards to connect a USB memory
Memo
device.
Setting the File Format
Set the format of the sample data file or target color data file to be saved into the USB memory.
[Operating Procedure]
1. Press the [MENU] button.
The <Configuration> screen is displayed.
(USB
4
E141