Konica Minolta cm-5 Instruction Manual page 101

3. Use the or button of the cross key to move the
cursor to the desired item.
Settings
 Reflectance/Transmittance: "Spectral" screen shows
reflectance (or transmittance) graph without reflectance (or
transmittance) data at selected wavelengths.
 Absorbance: "Spectral" screen shows absorbance graph
without absorbance data at selected wavelengths.
 Refl/Tra + Specific Wavelength: "Spectral" screen shows
reflectance (or transmittance) graph and reflectance (or
transmittance) data at up to three selected wavelengths.
 Absorbance + Specific Wavelength: "Spectral" screen
shows absorbance graph and absorbance data at up to three
selected wavelengths.
4. Press the [OK/Edit] button.
The selection is confirmed and the screen returns to the
<Spectral Graph Settings> screen.
If you press the [Back] button without pressing the [OK/
Notes
Edit] button, you return to the <Spectral Graph
Settings> screen without changing the setting.
5. To change the wavelength of the spectral data to be
displayed, use the
move the cursor to "Specific Wavelength 1" and then
press the [OK/Edit] button.
The cursor color turns to blue and ▲ and ▼ are displayed
above and below the cursor.
6. Use the or button of the cross key to change the
wavelength.
• The wavelength increases/decreases by 10 nm with each
button press.
• Holding down the
increases/decreases the wavelengths by 10 nm continuously.
or button of the cross key to
or button of the cross key
2
E99