Konica Minolta cm-5 Instruction Manual page 148

Pin No.-Signal Connection Diagram for Printer Cable
• For a D-sub 9-pin connector
Instrument side
Pin No.
3
5
8
• For a D-sub 25-pin connector
Instrument side
Pin No.
3
5
8
Setting the Communication Parameters
Set the communication parameters between the instrument and serial printer.
[Operating Procedure]
1. Press the [MENU] button.
The <Configuration> screen is displayed.
2. Use the or
to move the cursor to "Output" and then press the [OK/
Edit] button.
The <Output Settings> screen is displayed.
E146
Signal
TXD
GND
CTS
Signal
TXD
GND
CTS
and or buttons of the cross key
Printer side
(D-sub 9-pin connector)
Signal Pin No.
DATA 3
GND 5
BUSY 8
Printer side
(D-sub 25-pin connector)
Signal Pin No.
DATA 2
GND 5
BUSY 7