Auto Target - Konica Minolta cm-5 Instruction Manual

Auto Target

Use this function to automatically select the target color with the smallest color difference (ΔE*ab) for
measurement.
The target color will be selected from those with the same specular component mode and other measurement
Memo
condition settings for the measurement.
• Do not use this function if you want to control the color difference from a specific target color.
Notes
• This setting will not be applied to the sample data obtained before this function was set to ON.
[Setting Procedure]
1. Use the or
"All" tab, use the
"Auto Target" and then press the [OK/Edit] button.
The <Auto Target> screen is displayed.
2. Use the or
cursor to "ON" or "OFF".
Settings
 ON: Use the Auto Target function for measurement.
 OFF: Do not use the Auto Target function.
3. Press the [OK/Edit] button.
The selection is confirmed and the screen returns to the
<Sample> detail screen.
If you press the [Back] button without pressing the [OK/
Notes
Edit] button, you return to the <Sample> detail screen
without changing the setting.
E132
Start the procedure from the <Sample Data Function> screen.
button of the cross key to select the
or button to move the cursor to
button of the cross key to move the