Konica Minolta cm-5 Instruction Manual page 137

3. Make sure that (Ready to measure) is displayed and
then press the measuring button.
The specimen is measured and the <Manual Average
Measurement> screen is displayed.
The <Manual Average Measurement> screen shows the
result of the statistic calculation using the sample data of the
measurements performed so far.
Memo
• If you use the
"Finish" and press the [OK/Edit] button, you can finish
the manual averaging before the specified number of
measurements is completed and the averaging result of
the measurements performed so far is added to the
<Sample> screen as new sample data.
• If you use the
the cursor to "Cancel" and press the [OK/Edit] button,
you can cancel the manual averaging.
4. Place the specimen at the next measuring position and
repeat the steps from 1 to 3.
When the specified number of measurements has been
completed, the final result of the statistic calculation will be
shown. Check that "Finish" is selected and press the [OK/
Edit] button. The averaging result will be displayed on the
<Sample> screen as new sample data.
or
button of the cross key to select
or
button of the cross key to move
3
E135