Initialization - Konica Minolta cm-5 Instruction Manual

Initialization

Reset the settings of the instrument to the initial status.
• Do not initialize the instrument unless necessary.
Notes
• The sample data, target color data, tolerances set to each target color and default tolerance settings
will be protected and not be deleted by initialization.
The sample data and target color data which you saved will be stored even after initialization.
Memo
For details of the initial setting values, refer to page 156 "Initial Settings".
[Operating Procedure]
1. Turn ON the instrument while holding down the
[Target/Sample] button.
The <Initialize> screen is displayed.
2. Use the or button of the cross key to move the
cursor to "OK" and then press the [OK/Edit] button.
"WR123 Please Restart Instrument." is displayed.
If you place the cursor on "Cancel" on the <Initialize>
Memo
screen and press the [OK/Edit] button, the initialization is
canceled and the <Sample> screen is displayed.
3. Turn OFF the instrument once and then turn it ON
again. The system starts with the initialized settings.
4
E155