Quick Setting Wizard - Konica Minolta cm-5 Instruction Manual

Quick Setting Wizard

When you use the instrument for the first time, you can set the measurement conditions and calibrate the
instrument step by step by following the instructions on the screen.
[Procedure]
1.
Turn the instrument ON. The
<Welcome to Easy Setup Wizard!>
screen appears after the initial screen.
• The Easy Setup Wizard can also be
entered by holding the [Menu]
button pressed for a long time.
• If you want to save condition
settings to a USB memory device,
connect a USB memory device to
the instrument before continuing.
2. Use the or button of the cross key to
move the cursor to "Start Simple Wizard"
and then press the [OK/Edit] button.
3.
The <Measurement Type Selection>
screen appears.
Memo
To move the cursor to
select a setting item, press
button of the
the or
cross key.
4. Go to the appropriate step according to the measurement type.
<Reflectance measurement> Refer to Steps 4 to 20 (Pages 30 to 33).
<Reflectance measurement using Petri Dish> Refer to Steps 4 to 18 (Pages 33 to 36).
<Transmittance measurement> Refer to Steps 4 to 13 (Pages 37 to 39).
<Liquid transmittance measurement> Refer to Steps 4 to 12 (Pages 39 to 41).
To move the cursor
between "Exit",
"Previous" and "Next",
press the or button
of the cross key.
When you select "Exit"
and then press the [OK/
Edit] button, the wizard is
interrupted and the
<Sample> screen is
displayed.
When you select
"Previous" and then press
the [OK/Edit] button, the
screen which was
displayed immediately
before the Quick Setting
Wizard is displayed.
E29
2