Auto Measure; Ribbon Near End - SATO CL4NX Operator's Manual

Auto Measure

Printing > Auto Measure
The printer measures the length of the media automatically.
The measured length of media will be saved in Label Length automati-
cally.
Available when you have selected Gap or I-Mark in Sensor Type menu.
The setting procedures of label length using Auto Measure function are as
follows:
1. Install the media.
2. Set Auto Measure to Enabled.
3. Press the button or the
screen.
4. Open the print head. (Head Open error occurs)
5. Close the print head. (Go back to offline screen)
6. When you press the
and measures the label length.
7. The measured label length will be saved in Label Length.
Note:
When you have set Auto Measure to Enabled, this function executes
when the printer powers on.
Ribbon
Printing > Ribbon
Set whether to use carbon ribbon or direct thermal paper to print.
The options are as follows:
• Use Ribbon: Print with carbon ribbon.
• Direct Thermal: Print with direct thermal paper.

Ribbon Near End

Printing > Ribbon Near End
Set whether or not to show the warning icon when the carbon ribbon is
about to run out.
The options are as follows:
• Enabled: Show the warning icon.
• Disabled: Do not show the warning icon.
Note:
The warning icon shows in the status bar on the upper part of the screen.
button to show the online or offline
button, the printer feeds two pieces of label
4 Operation and Configuration
CL4NX Operator Manual
69