Chrysler 2005 Crossfire SRT6 Service Manual page 1957

ZH
(P0106) MAP SENSOR PERFORMANCE (CONTINUED)
19.
MAP SENSOR SIGNAL CIRCUIT OPEN
Turn the ignition off.
Disconnect the PCM C3 harness connector.
Note: Check connectors — Clean/repair as necessary.
Measure the resistance of the MAP Sensor Signal circuit from the
PCM C3 harness connector to the MAP Sensor harness connector.
Is the resistance below 5.0 ohms?
Yes >> Replace and program the Powertrain Control Module.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/POWERTRAIN
REMOVAL).
Perform POWERTRAIN VERIFICATION TEST - VER 2.
No >> Repair the MAP Sensor Signal circuit for an open.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
20.
INTERMITTENT WIRING AND CONNECTORS
The condition that caused this DTC to set is currently not present. Inspect the related wiring harness for a possible
intermittent condition.
Note: Check connectors — Clean/repair as necessary. Poor pin to terminal connections can set DTCs.
Using the wiring diagrams as a guide, inspect the wiring and connectors specific to this DTC. Wiggle the wires while
checking for shorts and/or open circuits.
Note: Check for any Technical Service Bulletins that may apply.
Were any problems found?
Yes >> Repair as necessary.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
No >> Test Complete.
CONTROL MODULE
ENGINE - ELECTRICAL DIAGNOSTICS 9 - 33
-