Heating And Ventilation System - Isuzu 2000 Trooper Workshop Manual

Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Mix Actuator . . . . . . . . . . . . . . . . . . . . . . . . . .
Removal . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Service Precaution
WARNING: THIS VEHICLE HAS A SUPPLEMENTAL
RESTRAINT SYSTEM (SRS). REFER TO THE SRS
COMPONENT AND WIRING LOCATION VIEW IN
ORDER TO DETERMINE WHETHER YOU ARE
PERFORMING SERVICE ON OR NEAR THE SRS
COMPONENTS OR THE SRS WIRING. WHEN YOU
ARE PERFORMING SERVICE ON OR NEAR THE SRS
COMPONENTS OR THE SRS WIRING, REFER TO
THE SRS SERVICE INFORMATION. FAILURE TO
FOLLOW WARNINGS COULD RESULT IN POSSIBLE
AIR BAG DEPLOYMENT, PERSONAL INJURY, OR
OTHERWISE UNNEEDED SRS SYSTEM REPAIRS.
General Description
Heater
When the engine is warming up, the warmed engine
coolant is sent out into the heater core. The heater system
supplies warm air into the passenger compartment to
warm it up.
Outside air is circulated through the heater core of the
heater unit and then back into the passenger
compartment. By controlling the mixture of outside air and
heater core air, the most comfortable passenger
compartment temperature
maintained.
The temperature of warm air sent to the passenger
compartment is controlled by the temperature control
knob. This knob acts to open and close the air mix door,
thus controlling the amount of air passed through the
heater core.
The air selector knob, with its different modes, also allows
you to select and maintain the most comfortable
passenger compartment temperature.
The air source select lever is used to select either
"FRESH" for the introduction of the outside air, or
"RECIRC" for the circulation of the inside air. When the
lever is set to "FRESH", the outside air is always taken
into the passenger compartment. When setting the lever
to "RECIRC" position, the circulation of air is restricted
only to the inside air with no introduction of the outside air
and the air in the passenger compartment gets warm
quickly. However, the lever is normally set to "FRESH" to
prevent the windshield from clouding.
HEATING, VENTILATION AND AIR CONDITIONING (HVAC)
1A–138
1A–138
1A–138
1A–138

Heating and Ventilation System

can be selected and
Intake Actuator . . . . . . . . . . . . . . . . . . . . . . . .
Removal . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . .
CAUTION: Always use the correct fastener in the
proper location. When you replace a fastener, use
ONLY the exact part number for that application.
ISUZU will call out those fasteners that require a
replacement after removal. ISUZU will also call out
the fasteners that require thread lockers or thread
sealant. UNLESS OTHERWISE SPECIFIED, do not
use supplemental coatings (Paints, greases, or other
corrosion inhibitors) on threaded fasteners or
fastener joint interfaces. Generally, such coatings
adversely affect the fastener torque and the joint
clamping force, and may damage the fastener. When
you install fasteners, use the correct tightening
sequence and specifications. Following these
instructions can help you avoid damage to parts and
systems.
1A–3
1A–139
1A–139
1A–139