Installation - Isuzu 2000 Trooper Workshop Manual

5D–6 PARKING BRAKE
6. Remove bolt.
7. Remove back plate.
8. Remove clip (frame side).
9. Remove clip (suspension side).
10. Remove holding spring.
11. Remove return spring; upper.
12. Remove return spring; lower.
13. Remove the brake shoe assembly. Then remove the
parking brake cable from the parking brake lever (1).
14. Remove cable fixing bolt.
15. Remove rear cable.

Installation

1. Install rear cable and apply grease (BESCO L–2 or
equivalent) to the connecting portion of the rear cable
and the equalizer.
2. Install cable fixing bolt and tighten the cable fixing bolt
to the specified torque.
Torque: 6 N·m (52 lb in)
3. Install shoe assembly and after installation of the
shoe and cable assembly, apply the special grease
included in the repair kit to the portions indicated in the
illustration.
4. Install return spring; lower.
5. Install return spring; upper and the parking brake
lever (3) side (secondary side) return spring must be
installed on the outer side (2) of the primary side
return spring.
308RW001
6. Install holding spring.
7. Install clip (suspension side) and tighten the bolt to
the specified torque.
Torque: 7.8 N·m (68 lb in)
8. Install clip (frame side) and tighten the bolt to the
specified torque.
Torque: 15 N·m (11 lb in)
9. Install back plate.
10. Install bolt and tighten the bolt to the specified torque.
Torque: 6 N·m (52 lb in)
11. Install clip (floor side) and tighten the bolt to the
specified torque.
Torque: 15 N·m (11 lb in)
12. Install rotor.
308RS002
308RW002