Isuzu 2000 Trooper Workshop Manual page 264

REAR SUSPENSION
3D–4
Inspection and Repair
Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal conditions are
found through inspection.
Check the following parts:
D Coil spring
D Insulator
Installation
1. Install coil spring and make sure that the coil spring is
installed in the proper position. Paint mark(1) should
be downward.
2. Fit the end of the coil spring to the coil spring seat and
mount the coil spring on the rear axle case.
3. Install the insulator on the coil spring. Jack up the axle
case gently with the top of the coil spring set to the
spring seat on the frame side.
4. Install shock absorber and tighten the nut lightly,then
retighten it to the specified torque after the vehicle is
at curb height.
NOTE: When mounting shock absorber, be sure not to
use grease on bushings or any other nearby part.
Torque: 78 N·m (58 lb ft)
5. Install stabilizer bar.
Torque: 50 N·m (37 lb ft)
6. Install parking brake cable bracket.
460RW001
460RS003
460RS004