Isuzu 2000 Trooper Workshop Manual page 743

6A–30 ENGINE MECHANICAL
Legend
(1) Up Side
(2) Down Side
(3) Direction for Installation
(4) Locking Pin
3. Remove double clips from timing belt pulleys.
Turn the crankshaft pulley clockwise by two turns.
Torque : 25 N·m (18 lb ft)
3. Install timing belt cover.
Remove crankshaft pulley that was installed in step
1 item 5.
Tighten bolts to the specified torque.
Torque: 19 N·m (14 lb ft)
Legend
(1) Timing Belt Cover RH
(2) Timing Belt Cover LH
(3) Timing Belt Cover Lower
014RW011
Legend
(1) Timing Belt Cover
(2) Rubber Bushing
(3) Sealing Rubber
(4) Cylinder Body
4. Install crankshaft pulley using J-8614-01, hold the
crankshaft pulley and tighten center bolt to the
specified torque.
Torque : 167 N·m (123 lb ft)
5. Install fan pulley bracket and tighten fixing bolts to the
specified torque.
Torque : 22 N·m (16 lb ft)
6. Install power steering pump assembly and tighten to
the specified torque.
Torque :
M8 bolt : 22 N·m (16 lb ft)
M10 bolt : 46 N·m (34 lb ft)
7. Install cooling fan assembly and tighten bolts/nuts to
the specified torque.
Torque : 22 N·m (16 lb ft) for fan pulley and fan
bracket.
Torque : 10 N·m (88.5 lb in) for fan and clutch
assembly.
020RW004
020RW003