Cylinder Head Cover Rh; Removal; Installation - Isuzu 2000 Trooper Workshop Manual

Table of Contents

Advertisement

Removal

1. Disconnect battery ground cable.
2. Remove engine cover from the dowele on the
common chamber.
3. Disconnect ventilation hose from cylinder head cover.
4. Disconnect three ignition coil connectors from ignition
coils and remove harness bracket bolts on cylinder
head cover then remove ignition coil fixing bolts on
ignition coils and remove ignition coils.
5. Disconnect fuel injector harness connector then
remove fuel injector harness bracket bolt.
6. Remove eight fixing bolts then the cylinder head
cover.

Cylinder Head Cover RH

Installation

F06RY001
010RW002
ENGINE MECHANICAL
1. Install cylinder head cover.
D Clean the sealing surface of cylinder head and
cylinder head cover to remove oil and sealing
materials completely.
Apply sealant (TB-1207B or equivalent) bead
(diameter 2-3 mm) at eight places of arched areas
of camshaft bracket on front and rear sides.
D The cylinder head cover must be installed within 5
minutes after sealant application to prevent
premature hardening of sealant.
D Tighten bolts to the specified torque.
Torque : 9 N·m (80 lb in)
2. Tighten fuel injector harness bracket bolts to
specified torque then reconnect fuel injector harness
connector.
Torque : 7.8 N·m (5.7 lb ft)
3. Connect ignition coil connector and tighten ignition
coil fixing bolts to specified torque.
Torque : 4 N·m (35 lb in)
4. Connect ventilation hose to cylinder head.
5. Install engine cover mating with the dowels.
6A–21
014RW019

Advertisement

Table of Contents
loading

Table of Contents