Reassembly - Isuzu 2000 Trooper Workshop Manual

Measure inner diameter of bushing in the rear cover, and
replace if it exceeds the limit.
Standard: 12.50 mm to 12.527 mm (0.492 in to
0.4932 in)
Limit: 12.60 mm (0.4961 in)
Measure inner diameter of bushing in the center bracket
(P), and replace if it exceeds the limit.
Standard: 18.01 mm to 18.127 mm (0.7091 in to
0.7137 in)
Limit: 18.15 mm (0.7146 in)
STARTING AND CHARGING SYSTEM

Reassembly

To install, follow the removal steps in the reverse order,
noting the following points:
Grease application places
D Bushing in rear cover and center bracket
D Gears in reduction gear
D Shift lever operating portion
D Sliding portion of pinion
D Plunger sliding portion of magnetic switch
Reassembling Yoke Assembly
Before reassembly, make sure that no metallic parts
attach to the yoke assembly. Because of strong magnetic
force, hold the yoke assembly and insert it slowly into the
armature.
Torque
Torque for each part (See Torque Specifications in
this section)
Pinion Jump–out Dimension
Connect the "+" cable of battery to terminal S and the "–"
cable to terminal M. Turn the switch on, and measure
pinion travel dimension in thrust direction from the
065RS028
jump–out position.
In measuring the dimension, pull the pinion out a little in
the arrow direction.
Dimension(L): 0.05 mm to 1.5 mm (0.002 in to
0.06 in)
065RS029
6D3–13
065RS030