6A–24
ENGINE MECHANICAL
Removal
1. Disconnect battery ground cable.
2. Remove transfer case skid plate.
3. Remove 3rd crossmember.
4. Disconnect Heated oxygen (O
5. Remove the three stud nuts from the front exhaust
pipe flange and two nuts from the rear exhaust pipe
flange.
Legend
(1) O
Sensors
2
(2) Exhaust Front Pipe LH
(3) Transfer Case Skid Plate
(4) 3rd Crossmember
6. Remove heat protector two fixing bolts and remove
unit.
7. Remove a bolt on engine LH side for air conditioner
(A/C) compressor bracket and loosen two bolts for
A/C compressor then move A/C compressor to front
side.
8. Remove exhaust manifold eight fixing nuts and
remove exhaust manifold from the engine.
Exhaust Manifold LH
) sensor connector.
2
035RX015
Installation
1. Install exhaust manifold and gasket and tighten
exhaust manifold fixing nuts to the specified torque
with new nuts.
Torque: 52 N·m (38 lb ft)
2. Install heat protector.
3. Install exhaust front pipe's three stud nuts and rear
pipe's two nuts to the specified torque.
Torque :
Stud nuts: 67 N·m (49 lb ft)
Nuts: 43 N·m (32 lb ft)
4. Set A/C compressor to normal position and tighten
two bolts to the specified torque.
Torque : 40 N·m (30 lb ft)
5. Reconnect O
sensor connectors.
2
6. Install 3rd crossmember.
7. Install transfer case skid plate.