Isuzu 2000 Trooper Workshop Manual page 216

2A–48 POWER ASSISTED SYSTEM
5. Loosen the inflator module fixing bolt from behind the
steering wheel assembly using a TORX
equivalent until the inflator module can be released
from steering assembly.
6. Disconnect the yellow 2-way SRS connector located
behind the inflator module.
WARNING: THE INFLATOR MODULE SHOULD
ALWAYS BE CARRIED WITH THE URETHANE
COVER AWAY FROM YOUR BODY AND SHOULD
ALWAYS BE LAID ON A FLAT SURFACE WITH THE
URETHANE SIDE UP.
BECAUSE A FREE SPACE IS PROVIDED TO ALLOW
THE AIR CUSHION TO EXPAND IN THE UNLIKELY
EVENT OF ACCIDENTAL
OTHERWISE, PERSONAL INJURY MAY RESULT.
7. Disconnect horn lead.
8. Remove steering wheel fixing nut.
driver or
827RT008
THIS IS NECESSARY
DEPLOYMENT.
827RS016
9. Apply a setting mark (1) across the steering wheel
and shaft so parts can be reassembled in their original
position, then remove steering wheel.
10. Move the front wheels to the straight ahead position,
then use steering wheel remover J–29752 to remove
the steering wheel.
CAUTION: Never apply force to the steering wheel
in direction of the shaft by using a hammer or other
impact tools in an attempt to remove the steering
wheel. The steering shaft is designed as an energy
absorbing unit.
430RW001
430RT009