Isuzu 2000 Trooper Workshop Manual page 581

6. Using the bearing remover J-22912-01, remove the
ball bearing from the input shaft.
7. Remove the thrust plate.
8. Remove the carrier assembly.
9. Remove the snap ring from the carrier assembly.
10. Remove the circular hub.
11. Remove the snap ring before the ring gear.
265RW004
12. Using the special tool J-42806, remove the ring gear.
NOTE: Removing the ring gear needs a high-load press.
This means the transfer case may be damaged. To
remove and replace the ring gear, it is recommended that
the transfer case assembly should be replaced.
265RW006
TRANSFER CASE (TOD)
4D2–25
261RW025
261RW011