Isuzu 2000 Trooper Workshop Manual page 265

Shock Absorber and Associated Parts
Legend
(1) Bolt and Nut
Removal
1. Remove shock absorber fixing nut and washer.
2. Remove shock absorber fixing bolt and nut.
3. Remove shock absorber.
Inspection and Repair
Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal conditions are
found through inspection.
Check the following parts:
D Shock absorber
D Rubber bushing (Axle side)
NOTE: When mounting rubber bushings, be sure not to
use grease on bushings or any other nearby part.
Installation
1. Install shock absorber. When mounting shock
absorber, be sure not to use grease on bushings or
any other nearby part.
Shock Absorber
(2) Shock Absorber
(3) Nut and Washer
2. Install bolt and nut, then tighten the bolt and nut lightly.
Retighten to the bolt and nut specified torque after the
vehicle is at curb height.
Torque: 95 N·m (70 lb ft)
3. Install nut and washer, then tighten the nut lightly.
Retighten to the nut specified torque after the vehicle
is at curb height.
Torque: 78 N·m (58 lb ft)
REAR SUSPENSION
3D–5
461RW002