Power Steering Pump Disassembled View 2A-30; Disassembly - Isuzu 2000 Trooper Workshop Manual

2A–30 POWER ASSISTED SYSTEM
Power Steering Pump Disassembled View
Legend
(1) Bolt
(2) Suction Pipe
(3) O-ring
(4) Front Housing
(5) Snap Ring
(6) Shaft Assembly
(7) Bearing
(8) Shaft
(9) Retaining Ring
(10) Oil Seal
(11) O-ring
(12) O-ring
(13) Gasket

Disassembly

1. Clean the oil pump with solvent (plug the discharge
and suction ports to prevent the entry of solvent). Be
careful not to expose the oil seal of shaft assembly to
solvent.
2. Remove the bolt.
3. Remove the suction pipe.
4. Remove the O-ring.
5. Remove the connector.
6. Remove the O-ring.
(14) Rear Housing Assembly and Pump Cartridge
(15) Side Plate
(16) Rotor and Vane
(17) Pin
(18) Cam
(19) Rear Housing
(20) Bolt
(21) Spring
(22) Retaining Ring
(23) Filter
(24) Valve
(25) O-ring
(26) Connector
(27) Pressure Switch
7. Remove the valve.
8. Remove the retaining ring.
9. Remove the filter.
10. Remove the spring.
11. Remove the snap ring.
12. Remove the shaft assembly.
13. Remove the retaining ring.
14. Remove the oil seal.
CAUTION: When removing the oil seal, be careful
not to damage the housing.
412RX005