Isuzu 2000 Trooper Workshop Manual page 562

4D2–6 TRANSFER CASE (TOD)
2. Using the oil seal installer J-42804, attach the oil seal.
NOTE: When attaching the oil seal, pay attention to the
direction.
3. Mount the rear companion flange, O-ring , washer,
and nuts to the transfer in this order.
4. Using the flange holder J-8614-11, set the end nut.
Torque : 167 N·m (123 lb ft)
5. Using the punch J-39209, stake the end nut at two
places.
NOTE: Check the staked end nut is free from cracks.
6. Connect the rear propeller shaft to the transfer case
and tighten to the specified torque.
Torque : 63 N·m 46 (lb ft)
261RW035
266RW020
260RW007