Reassembly - Isuzu 2000 Trooper Workshop Manual

4C–22
DRIVE SHAFT SYSTEM

Reassembly

1. Install DOJ case to bracket.
2. Install oil seal and fix snap ring.
3. Install bearing and fix snap ring.
4. Install bracket to axle case. Tighten the bracket bolt to
the specified torque.
Torque: 116 N·m (85 lb ft)
5. Apply 150g of the specified grease in BJ .
6. Install dust seal .
7. Apply a thin coat of grease to the shaft for smooth
installation then install bellows.
8. Install band. Note the setting direction.
installation, check that the bellows is free from
distortion.
9. Install another bellows and fix band.
10. Install the ball guide with the smaller diameter side
ahead onto the shaft.
11. Install ball retainer.
12. Using snap ring pliers, install the snap ring (1)
securing the ball retainer to the shaft.
After
13. Align the track on the ball (1) retainer with the window
in the cage, and install the six balls into position.
412RS017
412RS013
412RS018