Starter; Removal; Installation - Isuzu 2000 Trooper Workshop Manual

Removal

1. Battery ground cable.
2. Disconnect Heated O
2
3. Remove exhaust front left pipe(2).
4. Remove heat protector(3).
5. Disconnect starter wiring connector from terminals
"B" and "S"(4).
6. Remove starter assembly mounting bolts on inside
and outside(5).
7. Remove starter assembly toward the bottom of
engine(6).

Installation

1. Install starter assembly(6).
Sensor connector (1).
035RW016
065RW027
STARTING AND CHARGING SYSTEM

Starter

2. Install mounting bolts and tighten bolts to specified
torque(5).
Torque: 40 N·m (30 lb ft)
3. Reconnect the connectors to terminals "B" and "S"
and tighten Terminals "B" to specified torque.
Torque: 9 N·m (80 lb in)
4. Install heat protector(3).
5. Install exhaust front left pipe and tighten bolts and
nuts to specified torque(2).
Stud Nuts
Torque: 67 N·m (49 lb ft)
Nuts
Torque: 43 N·m (32 lb ft)
6. Connect Heated O
7. Reconnect the battery ground cable.
6D3–5
Sensor connector (1).
2
065RW027
035RW016