Reassembly
1. Install outer bearing outer race by using installer
J–44461 and grip J–8092.
2. Install inner bearing outer race by using installer
J–44462 and grip J–8092.
3. Adjust the drive pinion mounting distance as follows:
1. Apply gear oil to the inner and outer drive pinion
bearing. Clean the pinion setting gauge set.
Then install the gauge set together with the inner
and outer bearings.
Install gauge plate J–42826 (3), inner pilot J–42827
(2) ,stud and nut J–21777–43 (4) and outer pilot
J–42824 (1) through inner and outer bearings.
2. Tighten the nut to the specified torque.
Torque: 2.3 N·m (20 lb in)
3. Clean the side bearing bores. Place discs and dial
425RY00011
indicator on to arbor, and place tool into position in
side bearing bores. Install and tighten the bearing
caps to the specified torque.
425RY00012
Legend
(1) Dial Indicator: J–8001
(2) Gauge Plate: J–44451
(3) Disc (2 pcs.): J–44452
(4) Arbor: J–23597–1
DIFFERENTIAL (REAR)
4A2–17
425RW030
425RW031