Control Panel Illumination Bulb - Isuzu 2000 Trooper Workshop Manual

1A–28 HEATING, VENTILATION AND AIR CONDITIONING (HVAC)
D Air source control cable.
1. Slide the control lever to the left ("CIRC"
position).
2. Connect the control cable at the "CIRC" position
of the link unit of the blower assembly and
secure it with the clip.
D Temperature control cable.
1. Turn the control knob to the left ("MAX COLD"
position).
Control Panel Illumination Bulb and Associated Parts
Legend
(1) Control Lever Assembly
Removal
1. Disconnect the battery ground cable.
2. Remove control lever assembly.
D Refer to Control Lever Assembly in this section.
3. Pull out the bulb socket from the panel by turning it
counterclockwise.
4. Pull the illumination bulb from the socket.
Installation
To install, follow the removal steps in the reverse order.

Control Panel Illumination Bulb

2. Connect the control cable at the "COLD"
position of the temperature control link of the
heater unit and secure it with the clip.
D Air select control cable
1. Turn the control knob to the right ("DEFROST"
position).
2. Connect the control cable at the "DEFROST"
position of the mode control link of the heater
unit and secure it with the clip.
2. Check the control cable operation.
(2) Bulb Socket
(3) Illumination Bulb
865RS007