Inspection And Repair; Installation; Differential (Rear) - Isuzu 2000 Trooper Workshop Manual

3. Remove flange nut and washer by using pinion flange
holder J–8614–01 after raising up its staked parts
completely.
4. Remove flange.
5. Remove oil seal.
6. Remove outer bearing by using remover J–39602.
7. Remove collapsible spacer.

Inspection and Repair

Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal conditions are
found through inspection.
Check the following parts:
1. Seal surface of the pinion.
2. Cage bore for burns.

Installation

1. Install collapsible spacer, discard the used collapsible
spacer and install a new one.
2. Install outer bearing.
NOTE: Do not drive in, but just temporarily set in the outer
bearing by hand, which should be indirectly pressed in
finally by tightening the flange nut.
3. By using the seal installer J–37263, install a new oil
seal (1) that has grease on seal lip.
415RS018
4. Install flange.
5. Install flange nut and washer. Refer to Differential
Assembly in this section for flange nut reassembly.
NOTE: Discard the used nut and install a new one.
425RY00003

DIFFERENTIAL (REAR)

4A2–11
425RS004