Isuzu 2000 Trooper Workshop Manual page 337

4. Using punch J–39209, stake the flange nut at two
points.
NOTE: When staking, be sure to turn the nut to ensure
that there is no change in bearing preload. Make sure of
preload again as instructed in 3).
11. Adjust ring gear backlash.
1. Attach the side bearing to the differential
assembly without shims by using installer
J–42829 and grip J–8092.
2. Insert the differential cage assembly with bearing
outer races into the side bearing bores of the
carrier.
3. Using two sets of feeler gauges, insert a feeler
stock of sufficient thickness between each
425RS028
bearing outer race and the carrier to remove all
end play. Make certain the feeler stock is pushed
to the bottom of the bearing bores.
Mount the dial indicator J–8001 on the carrier so
that the indicator stem is at right angles to a tooth on
the ring gear.
425RW003
DIFFERENTIAL (REAR)
4A2–21
425RS030
425RS031