Isuzu 2000 Trooper Workshop Manual page 272

REAR SUSPENSION
3D–12
Stabilizer Bar and Associated Parts
Legend
(1) Nut and Washer
(2) Link
Removal
1. Raise the vehicle and support the frame with suitable
safety stands.
2. Remove wheel and tire assembly. Refer to Wheel
Replacement in this section.
3. Remove nut and washer.
4. Remove link.
CAUTION: Be careful not to damage the ball joint
boot.
5. Remove bracket.
Stabilizer Bar
(3) Bracket
(4) Rubber Bushing
(5) Stabilizer Bar
6. Remove rubber bushing.
7. Remove stabilizer bar.
Inspection and Repair
Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal conditions are
found through inspection.
Check the following parts:
D Stabilizer bar
D Rubber bushing
D Link ball joint
460RW020