Stoplight Switch; Removal; Installation - Isuzu 2000 Trooper Workshop Manual

5C–18 POWER ASSISTED BRAKE SYSTEM
11. Install lower cluster assembly.
12. Install front console assembly.

Removal

1. Remove shift knob.
2. Remove front console assembly.
3. Remove lower cluster assembly.
4. Remove instrument panel driver lower cover.
5. Remove driver knee bolster assembly.
6. Remove stoplight switch connector (3).
7. Remove lock nut (1).
8. Remove switch (2).

Installation

1. Install switch and adjust the stoplight switch to the
specified clearance (between the switch housing and
the brake pedal) by rotating the switch housing.
Clearance (1): 0-0.2 mm (0-0.009 in)
NOTE: While adjusting the installation of the stoplight
switch, make sure that the threaded part of the stoplight
switch does not push the brake pedal.
13. Install shift knob.

Stoplight Switch

2. Install lock nut.
3. Connect stoplight switch connector.
4. Install driver knee bolster assembly.
5. Install instrument panel driver lower cover.
6. Install lower cluster assembly.
7. Install front console assembly.
8. Install shift knob.
310RW004
310RY00001