Malfunction Indicator Lamp (Mil) "On" Steady; Circuit Description; Diagnostic Aids - Isuzu 2000 Trooper Workshop Manual

6E–92
TROOPER 6VE1 3.5L ENGINE DRIVEABILITY AND EMISSIONS

Malfunction Indicator Lamp (MIL) "ON" Steady

Circuit description

The malfunction indicator lamp (MIL) should always be
illuminated and steady with ignition "ON" and the engine
stopped. Ignition feed voltage is supplied directly to the
MIL indicator. The powertrain control module (PCM)
turns the MIL "ON" by grounding the MIL driver circuit.
The MIL should not remain "ON" with the engine running
and no DTC(s) set. A steady MIL with the engine running
and no DTC(s) suggests a short to ground in the MIL
driver circuit.

Diagnostic Aids

An intermittent may be caused by a poor connection,
rubbed-through wire insulation, or a wire broken inside
the insulation. Check for the following items:
D Poor connection or damaged harness – Inspect the
PCM harness and connectors for improper mating,
broken locks, improperly formed or damaged
terminals, poor terminal-to-wire connection, and
damaged harness.
Test Description
Number(s) below refer to the step number(s) on the
Diagnostic Chart.
2. If the MIL does not remain "ON" when the PCM is
disconnected, the MIL driver wiring is not faulty.
3. If the MIL driver circuit is OK, the instrument panel
cluster is faulty.
6. This vehicle is equipped with a PCM which utilizes
an electrically erasable programmable read only
memory (EEPROM). When the PCM is replaced,
the new PCM must be programmed. Refer to PCM
Replacement and Programming Procedures in
Powertrain Control Module (PCM) and Sensors.
D06RY00127