2A–60 POWER ASSISTED SYSTEM
15. Remove steering column cover.
16. Disconnect the wiring harness connectors located
under the steering column.
17. Remove the combination switch assembly with SRS
coil.
NOTE: SRS coil is a part of combination switch
assembly, which can not be replaced singly. Therefore,
be sure not to remove the SRS coil from the combination
switch assembly.
18. Remove snap ring.
19. Remove cushion rubber.
20. Remove shift lock cable (For A/T).
21. Disconnect the starter switch harness connector
located under the steering column, then remove lock
cylinder assembly.
22. Apply a setting mark (1) across the universal joint and
steering shaft to reassemble the parts in their original
position, then remove steering column assembly.
NOTE: A setting mark can be easily made if the shaft is
withdrawn a little by loosening the steering shaft universal
joint.
430RT009
Inspection
If the abnormal conditions are found through inspection,
replace the steering column assembly.
Column Capsule
Check capsules on steering column bracket assembly; all
must be securely seated in bracket slots and checked for
any loose conditions when pushed or pulled by hand.
825RW030
431RW004
431RW030