Heater Temperature Control Link Unit - Isuzu 2000 Trooper Workshop Manual

Installation
To install, follow the remove steps in the reverse order,
noting the following points:
1. Apply grease to the mode sub-lever and to the
abrasive surface of the heater unit.
Disassembled View
Legend
(1) Case (Temperature control)
(2) Clip
(3) Door Lever
Removal
1. Disconnect the battery ground cable.
2. Drain engine coolant.
3. Discharge and recover
conditioning).
D Refer to Refrigerant Recovery in this section.
4. Remove heater unit.
D Refer to Heater Unit in this section.
5. Remove the case (Temperature control) from the
heater unit.
6. Remove rod.
7. Remove sub-lever.
HEATING, VENTILATION AND AIR CONDITIONING (HVAC) 1A–19

Heater Temperature Control Link Unit

refrigerant (with
2. After installing the link unit, check to see if the link unit
operates correctly.
(4) Clip
(5) Heater Unit
(6) Rod
(7) Sub-lever
8. Pull out the door lever while raising up the catch of the
door lever.
9. Remove clip.
air
Installation
To install, follow the removal steps in the reverse order,
noting the following points:
1. Apply grease to the sub-lever and to the abrasive
surface of the heater unit.
2. After installing the link unit, check to see if the link unit
operates correctly.
860RS007