Installation - Isuzu 2000 Trooper Workshop Manual

2A–62 POWER ASSISTED SYSTEM
Tilt Mechanism
Tilt mechanism should moves smoothly.
While locked the tilt mechanism, be sure the steering
column latch securely by pushing the steering wheel
upward and downward.

Installation

1. Install steering column assembly.
2. Align the setting marks on the universal joint and
steering shaft made during removal.
3. Tighten the steering column fixing bolt (dash panel) to
the specified torque.
Torque: 19 N·m (14 lb ft)
4. Tighten the steering column fixing bolt
bracket) to the specified torque.
Torque: 17 N·m (13 lb ft)
5. Tighten the universal joint to the specified torque.
Torque: 25 N·m (18 lb ft)
6. Install lock cylinder assembly.
7. Install shift lock cable (For A/T).
8. Install cushion rubber.
9. Install snap ring.
10. Install Combination switch and SRS coil assembly.
After installation of combination switch assembly,
connect the combination switch wiring harness
connector and the SRS 2-way connector located
under the steering column.
11. Turn the SRS coil counterclockwise to full, return
about 3 turns and align the neutral mark.
CAUTION: When turning
counterclockwise to full, stop turning if resistance is
felt. Forced further turning may damage to the cable
in the SRS coil.
431RW035
(pedal
the SRS coil
12. When installing the steering column cover, be sure to
route each wire harness as illustrated so that the
harnesses do not catch any moving parts.
Legend
(1) Steering Column Cover
(2) Starter Switch Harness
(3) Combination Switch Harness
(4) Inflator Module Harness
13. Install steering wheel and align the setting marks
made when removing.
CAUTION: Never apply force to the steering wheel
in direction of the shaft by using a hammer or other
impact tools in an attempt to remove the steering
wheel. The steering shaft is designed as an energy
absorbing unit.
14. Tighten the steering wheel fixing nut to the specified
torque.
Torque: 34 N·m (25 lb ft)
15. Support the module and carefully connect the module
connector then install inflator module.
826RW014
825RW017