Installation - Isuzu 2000 Trooper Workshop Manual

4. Remove the drive belt.
5. Remove the pulley from the power steering pump.
6. Disconnect the suction hose.
7. Disconnect the flexible hose.
8. Remove the power steering pump fixing bolt.
9. Remove the pump assembly.
CAUTION: When removing the prmp assembly, be
careful not to damage the wiring harnessunder the
pump housing.

Installation

1. Install the adjust plate and tighten the mounting bolts
to the specified torque.
Torque: 56 N·m (41 lb ft)
2. Install the pump assembly. Connect the harness
under the pump housing.
3. Tighten the fixing bolt to the specified torque.
Torque: 46 N·m (34 lb ft)
4. Connect the flexible hose, then tighten the eye bolt to
specified torque.
Torque: 54 N·m (40 lb ft)
5. Connect the suction hose.
6. Install the pulley onto the power steering pump and
tighten the nut to the specified torque.
Torque: 78 N·m (58 lb ft)
7. Install the air cleaner duct and the radiator upper
hose.
8. Refill the engine coolant.
9. Fill and bleed the power steering system. Refer to
Bleeding the Power Steering System in this section.
POWER ASSISTED SYSTEM 2A–29