Inspection And Repair - Isuzu 2000 Trooper Workshop Manual

4A2–8 DIFFERENTIAL (REAR)
7. Remove the parking
bolts(Behind the back plate)(1).
8. Remove the bearing holder mounting nuts.
9. Remove axle shaft assembly.
NOTE: Be sure not to damage the oil seal.
10. Remove snap ring.
11. Using a bearing remover J–39211 and press, remove
retainer together with the bearing holder.
12. Remove bearing.
13. Remove bearing holder.
14. Remove back plate.
brake cable mounting
311RS001
420RS006
15. Remove the wheel pins using a remover J–6627–A.

Inspection and Repair

Make necessary correction or parts replacement if wear,
corrosion or any other abnormal conditions are found
through inspection.
Visual Check:
Check the following parts for wear, damage, noise or any
other abnormal conditions:
1. Axle shaft
2. Bearing
When checking the axle shaft, pay special attention to the
splined portions and replace the shaft if distortion or step
wear is noticeable. Correct slight step wear with a grinder.
420RS007
420RS008