Isuzu 2000 Trooper Workshop Manual page 499

2. Be careful not to permit the entry of water or dust into
the ports of the actuator.
Dimensional Check
Measure illustrated sizes 1, 2, and 3.
Limit
1=64.1 mm (2.52 in)
2=6.7 mm (0.26 in)
3=6.7 mm (0.26 in)
Reassembly
1. Install the new oil seal which has been immersed in
differential gear oil, by using an oil seal installer
J–41693 and grip J–8092.
2. Force a new needle bearing into inner shaft by using a
installer J–41694 and grip J–8092.
3. Place a new snap ring(internal) in inner shaft.
Force a new inner shaft bearing into the inner shaft by
using a installer J–37452 and press.
412RS037
4. Install snap ring(external).
NOTE: Be careful not to damage the inner shaft.
5. Clean the housing contact surface of the front axle
case and insert inner shaft assembly into the front
axle case.
NOTE: Be careful not to damage seal.
412RS043
DRIVE SHAFT SYSTEM
4C–29
412RS051
412RS044