Isuzu 2000 Trooper Workshop Manual page 227

CAUTION: The wheel of the vehicle must be straight
ahead and the steering column in the "LOCK"
position before disconnecting the steering column
from the steering gear. Failure to do so will cause the
SRS coil assembly to become uncentered which will
cause damage to the SRS coil assembly.
5. Disconnect the transmission (for M/T) and transfer
control lever knob.
6. Disconnect the wiring harness connectors.
7. Remove front console assembly.
8. Remove lower cluster assembly.
9. Remove the engine hood opening lever, then remove
steering lower cover.
10. Remove driver knee bolster (reinforcement).
11. Loosen the inflator module fixing bolt from behind the
steering wheel assembly using a TORX
equivalent until the inflator module can be released
from steering assembly.
12. Disconnect the yellow 2-way SRS connector located
behind the inflator module.
13. Remove inflator module.
WARNING: THE INFLATOR MODULE SHOULD
ALWAYS BE CARRIED WITH THE URETHANE
COVER AWAY FROM YOUR BODY AND SHOULD
ALWAYS BE LAID ON A FLAT SURFACE WITH THE
URETHANE SIDE UP.
BECAUSE A FREE SPACE IS PROVIDED TO ALLOW
THE AIR CUSHION TO EXPAND IN THE UNLIKELY
EVENT OF ACCIDENTAL
OTHERWISE, PERSONAL INJURY MAY RESULT.
driver or
827RT008
THIS IS NECESSARY
DEPLOYMENT.
POWER ASSISTED SYSTEM
14. Apply a setting mark (1) across the steering wheel
and shaft so parts can be reassembled in their original
position. Move the front wheels to the straight ahead
position, then use steering wheel remover J–29752 to
remove the steering wheel.
2A–59
827RS016
430RW001