Installation - Isuzu 2000 Trooper Workshop Manual

6A–20 ENGINE MECHANICAL

Installation

1. Install cylinder head cover.
D Clean the sealing surface of cylinder head and
cylinder head cover to remove oil and sealing
materials completely.
D Apply sealant (TB-1207B or equivalent) of bead
diameter 2-3 mm at eight place of arched area of
camshaft bearing cap on front and rear sides.
D The cylinder head cover must be installed with in 5
minutes after sealant application to prevent
hardning of sealant.
D Tighten bolts to the specified torque.
Torque : 9 N·m (80 lb in)
2. Install fuel injection harness bracket and tighten bolt
to the specified torque.
Torque : 9 N·m (80 lb in)
3. Connect ignition coil connector and ignition coil, then
tighten bolt to the specified torque.
Torque : 4 N·m (35 lb in)
Legend
(1) Ignition Coil Connector
(2) Bolt
(3) Ignition Coil Assembly
CAUTION: Ignition coil assembly #6 is different
from ignition coil assembly from #1 to #5. Ignition
coil assembly #6 is short type. So, note it when
installing ignition coil assembly of #6.
010RW008
Legend
(1) Long Type Ignition Coil Assemblies (# 1 ∼ # 5)
(2) Short Type Ignition Coil Assembly (# 6)
4. Connect ground cable and tighten bolts to the
specified torque.
Torque : 9 N·m (80 lb in)
5. Install positive crankcase ventilation hose.
6. Install engine cover mating with the dowels.
060RY022
060RY00002