Compressor Clutch Rotor And/Or Bearing; Removal; Installation - Isuzu 2000 Trooper Workshop Manual

installer is held and the center screw is rotated, the
key will wedge and will break the clutch hub.

Compressor Clutch Rotor and/or Bearing

Removal

1. Remove the clutch plate and hub assembly as
described previously.
2. Remove rotor (1) and bearing assembly retaining ring
(2), using snap ring pliers.
3. Install pulley rotor and bearing puller guide J-33023-A
to the front head and install J-41552 pulley rotor and
bearing puller down into the inner circle of slots (1) in
the rotor. Turn the J-41552 puller clockwise in the
slots in the rotor.
4. Hold the J-41552 puller in place and tighten the puller
screw against the puller guide to remove the pulley
rotor and bearing assembly.
HEATING, VENTILATION AND AIR CONDITIONING (HVAC) 1A–71
7. Remove installer J-33013-B, check for proper
8. Spin the pulley rotor by hand to see that the rotor is not
901RW002

Installation

1. With the compressor mounted to the J-34992 holding
901RW003
2. Position the J-33017 pulley, rotor and bearing installer
positioning of the shaft key (even or slightly above the
clutch hub).
rubbing the clutch drive plate.
fixture, position the rotor and bearing assembly on the
front head.
and J-33023-A puller pilot directly over the inner race
of the bearing.
871RW007