Isuzu 2000 Trooper Workshop Manual page 305

NOTE: When staking, be sure to turn the nut to insure
that there is no change in bearing preload. Make sure of
preload again as instructed in 3).
Legend
(1) 1.3mm or less
12. Install adjust shim.
1. Attach the side bearing to the differential
assembly without shims. Support the opposite
side using a pilot to prevent bearing damage.
Legend
(1) Drive handle:J–8092
(2) Installer:J–24244
(3) Pilot:J–8107–2
DIFFERENTIAL (FRONT)
2. Insert the differential cage assembly with bearing
outer races into the side bearing bores of the
carrier.
415RS012
3. Using two sets of feeler gauges, insert a feeler
stock of sufficient thickness between each
bearing outer race and the carrier to remove all
end play. Make certain the feeler stock is pushed
to the bottom of the bearing bores.
Mount the dial indicator J–8001 on the carrier so
that the indicator stem is at right angles to a tooth
on the ring gear.
425RS029
4A1–17
425RS030
425RS031