Installation - Isuzu 2000 Trooper Workshop Manual

4D1–8 TRANSFER CASE (STANDARD TYPE)
11. Off set the actuator assembly.
12. Remove the actuator assembly.
Legend
(7) Position: 4WD
(8) Mode: 2WD
13. Remove transfer case assembly.
14. Remove transfer rear case assembly.

Installation

1. Install transfer rear case assembly.
2. Install transfer case assembly and apply the
recommended liquid gasket (LOCTITE 17430) or its
equivalent to the transfer rear case fitting faces.
220RW028
3. Perform the following steps before fitting the transfer
rear case:
1. Shift the high–low shift to the 4H side.
2. Turn the select rod counterclockwise so that the
select block projection A may enter into the
2WD–4WD shift block.
3. The cut–away portion of the select rod head (9)
should align with that of the rear case hole's
stopper (10).
220RW029
4. Tighten the transfer rear case bolts to the specified
torque.
Torque: 37 N·m (27 lb ft)
5. Shift the 2WD–4WD shift rod (11) to the 4WD side.
220RS017
230RW004