Inspection And Repair; Installation - Isuzu 2000 Trooper Workshop Manual

3C 20
FRONT SUSPENSION

Inspection and Repair

Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal conditions are
found through inspection.
Check the following parts:
D Lower control arm
D Bushing

Installation

1. Install rear bushing by using installer J–36834.
2. Install front bushing by using installer J–36833.
901RW052
3. Install lower ball joint bolt.
4. Install torsion bar arm bolt.
5. Install lower control arm.
6. Install rear bolt.
7. Install front bolt.
8. Install lower ball joint and tighten it to the specified
torque.
Torque: 103 N·m (76 lb ft)
9. Install shock absorber and tighten it to the specified
torque.
Torque: 82 N·m (61 lb ft)
10. Install stabilizer link and tighten it to the specified
torque.
Torque: 50 N·m (37 lb ft)
11. Install torsion bar arm bracket and tighten it to the
specified torque.
Torque: 116 N·m (85 lb ft)
12. Install Torsion bar, refer to Torsion Bar Replacement
in this section.
901RW053
901RW036