3C 16
FRONT SUSPENSION
Installation
1. Install fulcrum pin.
2. Install bushing by using installer J–29755 and
J–39376.
3. Install plate.
4. Install nut and tighten fulcrum pin nut finger–tight.
NOTE: Torque fulcrum pin nut after adjusting buffer
clearance.
Buffer clearance: 20 mm (0.79 in)
Torque: 108 N·m (80 lb ft)
5. Install upper control arm assembly with the fulcrum
pin projections turned inward.
901RW049
Legend
(1) Projection
901RW050
(2) Outward
6. Install the caster shims(2) between the chassis frame
and fulcrum pin.
450RS012
450RS013