3C 12
FRONT SUSPENSION
8. Remove wheel speed sensor.
9. Remove back plate.
10. Remove lower ball joint by using remover J–29107.
CAUTION: Be careful not to damage the ball joint
boot.
11. Remove upper ball joint by using remover J–36831.
CAUTION: Be careful not to damage the ball joint
boot.
12. Remove knuckle assembly.
13. Remove oil seal.
14. Remove washer.
15. Remove needle bearing by using remover J–23907.
Inspection and Repair
Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal conditions are
901RW042
found through inspection.
Check the following parts:
D Knuckle
D Knuckle arm
D Needle bearing
D Thrust washer
Installation
1. Apply appropriate amount of multipurpose type
grease to the new bearing (Approx. 5 g)and install
needle bearing by using installer J–36838 and
J–8092.
901RW043
901RW044
901RW045