Isuzu 2000 Trooper Workshop Manual page 271

D Install the rubber bushing (Frame side) by using
Installer J–39215.
NOTE: When mounting rubber bushings, do not use
grease on bushings or any other nearby parts.
3. Rubber bushing (Axle side)
D Remove the rubber bushing (Axle side) by using
remover J–39792.
D Install the rubber bushing (Axle side) by using
installer J–39792.
Installation
1. Install lateral rod and make sure that the lateral rod is
in its correct position.
901RW061
NOTE: When mounting lateral rod, be sure not to use
grease on bushings or any other nearby part.
901RW062
Legend
(1) Frame Side
(2) Axle Side
2. Install bolt and nut. Tighten the bolt and nut lightly,
then retighten them to the specified torque after the
vehicle is at curb height.
Torque: 137 N·m (101 lb ft)
3. Install nut and washer. Tighten the nut lightly, then
retighten the nut to the specified torque after the
vehicle is at curb height.
Torque: 78 N·m (58 lb ft)
REAR SUSPENSION
3D–11
901RW063
460RS016