Table of Contents
Advertisement
How to Utilize This Installation Procedure
Illustrations Used in This Procedure
Illustrations used in this procedure are those of Booklet Finisher-D1 unless otherwise
specified.
Descriptions Used in This Procedure
In this procedure, Staple Finisher-D1 and Booklet Finisher-D1 are inclusively called the
•
finisher.
In this procedure, the machine connected to the upstream side of the finisher is called the
•
upstream connection machine.
For the procedure required only for the Staple Finisher-D1, the relevant section caption is
•
followed by "[Staple Finisher-D1 only]".
For the procedure required only for the Booklet Finisher-D1, the relevant section caption is
•
followed by "[Booklet Finisher-D1 only]".
When Using the Contained Parts (Bundled Components
in the Shipping Carton)
After unpacking, confirm the parts contained in the package by referring to the illustration
of "Bundled Components" described in this procedure. The below symbol appears on the
illustration of some steps when the parts contained in the shipping carton are to be used.
Mind this symbol to be aware the parts contained in the shipping carton are to be used.
6
Installation > How to Utilize This Installation Procedure > Symbols in the Illustration
F-6-2
F-6-2
6
Installation > How to Utilize This Installation Procedure > Symbols in the Illustration
Symbols in the Illustration
The frequently-performed operations/works are described with symbols in this procedure.
Check the description below.
Screw
Connector
Tighten
Remove
Connect
Prohibition
Checking
(Good/Bad)
instruction
Good
Bad
Check
Ins t ruction on direction
(front/rear, top/bottom)
Connect to
Turn ON
Push
the outlet
the switch
Remove the
F i t in the
Release/
projection
projection
remove
the claw
Harness
Disconnect
Connect/
Disconnect/
Secure
Free
Visual
Sound
check
check
Copy
Fit in/attach
the claw
F-6-3
F-6-3
6-2
6-2
- Quick Links:
- List of Parts
- List of Motors
Hide quick links:
Advertisement
Table of Contents
