Additional Serial Port On Cpc Card - Panasonic DBS-2.3-400 Programming Manual

Appendix C. EX 1.0 Feature Update

Additional Serial Port on CPC Card

Description
Installation
Page C-28
• You cannot chain-dial any PSD codes within an SSD number,
because the system would not be able to choose which extension to
take the PSD code from (the same PSD code might exist on multiple
extensions).
• You cannot "chain-within-a-chain". For example:
-- SSD Code 001 =
instead)
-- SSD Code 002 =
-- SSD Code 003 = 555-1212(will dial out)
(the above restriction applies to PSD codes as well)
• You cannot chain-dial PSD or SSD codes if they are both included in
each other's speed-dial number. For example:
-- SSD Code 000 =
instead)
-- SSD Code 001 =
instead)
2) The programming address for SSD Display Restriction (FF1 2# 1# 5#
[0 or 1]#) affects SSD codes 400-499.
• If disabled (i.e., set to "0"), the numbers assigned to SSD codes 400-
499 will display during dialing. The default is "0".
• If enabled (set to "1"), the numbers assigned to SSD codes 400-499
will not display during dialing.
• Numbers associated with SSD codes 000-399 will always display
during dialing.
The CPC-EX card contains an on-board serial port (Serial Port 2) which
can be used for Bus Monitor/ Remote Maintenance. This serial port
(labeled CN5) is located just above the LEDs on the front of the card (see
the illustration on -4). This additional serial port allows you to dial directly
into the system for remote maintenance, without having to disconnect the
SMDR cabling from the backplane serial port (Serial Port 1).
• Serial Port 1 (the backplane port) and Serial Port 2 have separate controls
for baud rate, stop bit, parity, and data length
Serial Port 2 requires the CPC-EX Serial Port Adapter Cable (VB-43890).
This cable connects to Serial Port 2 via a 10-pin connector, and to a
programming terminal via a DB25 connector.
DBS Manual - Revised April 2000
002(will not dial out; returns busy tone
AUTO
003(will dial out)
AUTO
001(will not dial out; returns busy tone
AUTO
000(will not dial out; returns busy tone
AUTO
Section 400-Programming
DBS-2.3/9.2-400