Table of Contents
Advertisement
Chapter 1. System Programming (FF1)
Notes
System Clock. The Automatic Day Mode start time depends on the DBS
system clock being set correctly.
NIGHT Key Operation. If only one of the Auto Mode Start Times is set, the
Attendant NIGHT key can be used to manually switch to another mode. For
instance, if Night mode has been activated automatically, the Attendant can
press the NIGHT key to go into Day mode. (However, the Attendant must
wait at least 3 minutes after the mode is automatically activated, before using
the NIGHT key to switch the mode again.)
In CPC-AII/B versions prior to 7.0, if both Auto Day and Auto Night Mode
Start Times are set, the Attendant NIGHT key cannot be used to manually
switch modes. (However, it will work in Version 7.0 or higher; or press #520
to toggle between Day, Night and Night 2 modes.)
Required Intervals Between Auto Day and Night Modes. If you set both
Auto Mode Start Times, it is recommended that the start times differ by at
least 1 hour.
Page 1-126
SUGGESTION (for versions prior to 7.0): Set only the Auto Night
Mode Start Time, so that the DBS will automatically switch to Night
mode each night -- and each morning the Attendant phone can press
the NIGHT key to manually switch to Day mode.
DBS Manual - Revised April 2000
Section 400-Programming
DBS-2.3/9.2-400
Advertisement
Table of Contents
