Red Alarm Detection - Panasonic DBS-2.3-400 Programming Manual

Section 400-Programming

Red Alarm Detection

Software Version: CPC-B Version 4.0 or higher
Address: Master Cabinet: FF1 8# 4# 4# 2# 1# (0-5)#
Slave Cabinet:
Description
The default value for this parameter is determined by network specifications.
It should not be changed.
If a red alarm occurs, the "CFA" LED on the T1 card lights. Also, if the Red
Alarm Relay (FF1 8# 4# 4/5# 4# 2#) is enabled, the alarm relay on the T1
MDF card closes.
Programming
Related Programming
Red Alarm Counter: FF1 8# 4# (4 or 5)# 3# 3# (0-9000)#
Red Alarm Relay: FF1 8# 4# (4 or 5)# 4# 2# (0 or 1)#
Red Alarm FF Key: FF5 (ExtPort)# (Key)# CONF (103# or 123#)#
DBS-2.3/9.2-400
FF1 8# 4# 5# 2# 1# (0-5)#
FF1 8# 4# (4 or 5)# 2# 1# (0-5)#
4=Master Cabinet
5=Slave Cabinet
DBS Manual - Revised April 2000
Chapter 1. System Programming (FF1)
0=4
1=6
2=8
3=10
4=12
5=14
Page 1-169